What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
12.06.2025 05:43

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
This is where the MOV conducts again, and dissipated the energy.
Oy: United Jet Flies Wrong Route Departing SFO, Causes Near Disaster - One Mile at a Time
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
But… the neutral is now “floating” because of the 1 ohm resistance.
Here is a simplified AC power diagram.
nine
But it can get overloaded, and no longer works.
This one hit behind the barn.
These glowing axolotls may hold the secret to human limb regeneration - MSN
These devices are installed between the “hot” and “neutral” and protective ground.
The MOV will conduct when the voltage exceeds 50% of line voltage.
2024–10–16 [ OO OLAOYE OYEBODE ]
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Why does Rahul Gandhi have so many haters?
In schematic diagrams this is the symbol for a fuse:
but this device (an Inductor) … impedes the rapid changes in the current.
He then asserts :
US imports plunge in early sign of Trump tariff impact - politico.eu
He then describes Rainy Season and Lightning.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Over 3,000 Private Credit Deals From Just 20 Analysts Raise Questions on Wall Street - Bloomberg.com
[old diagram got deleted by accident]
[image of Common-mode choke]
First Sentence:
Packers waive receiver, open up roster spot - Acme Packing Company
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
He then describes the function of a fuse.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Why do I feel like something bad is going to happen to me?
This is 'the assistant's answer'
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
A circuit breaker is similar, but is resettable.
What are some interview experiences with JP Morgan India?
Barnstars:
The other is “what does a “fuse” do?”
The bolt then partially travels down the line to your home.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
This is where this question deviates from being a 'generic' question, and becomes more specific.
Nintendo Switch 2 launch: GameStop investigating claims of console damage - NBC News
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Jessica Alba sunbathes in tiny bikini while ‘channeling chill’ on wellness getaway - Page Six
the problem then depends on "how fast does the fuse operate?".
So, the voltage could go up to 500 volts, and the fuse will not open up.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Nancy Wilson’s stolen custom-built Telecaster guitar was recovered by police in New Jersey - AP News
What is lightning?
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
How One Keto Trial Set Off a New War in the Nutrition World - WIRED
There are two important concepts here.
An AC voltage/ current source, and an ac inductive load.
A fuse is a non-resetable over current circuit protector.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
What does a fuse do?
One
One is “what exactly is in a ‘surge protector’ ? ”
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
2024–10–10[John johnson John Johnson ]
It seems Mohan does not understand the difference between a comment and an Answer.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
At least they know the answer if they wanted it.
a photo is worth a thousand words.
Edit 2024–10.
This device then solves the entire problem.
Now when you have a certain ac resistance, then a current flows in a loop.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
There are three different concepts here that are getting confused.
The third is lightning and “how it gets conducted into a home.”
(Dc diagram shown, AC is similar).
I post the exact comment here.
At one ohm, the resistor has a maximum of 1 watt power.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
For this case there are devices called Metal oxide varistors (MOV).
It also is a device that limits the change in current flow.
2024–10–14 [Omar Gharbi Omar Gharbi ]
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
so, what happens?
Because the load is inductive, the current lags the voltage.(by a bit).
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
These are simplified answers to the original question, and does not change anything I wrote above.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
what exactly is a ‘surge’ protector?
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Upvotes:
eight
but I think this circuit , shows a few more pieces.